Air Supply; Lubrication - CLAS OP 1513 Mode D'emploi

OP 1513
1/2" D. COMPACT IMPACT WRENCH 1084Nm DOUBLE HAMMER

AIR SUPPLY

1. Make sure the trigger is in the «off" position before connecting to the air supply.
2. You will need an air pressure of 6.3bar.
3. Attention! Ensure that the air supply is clean and does not exceed 6.3bar during use.
Excessive air pressure and impure air will shorten the life of the product due to excessive wear
and tear and can be dangerous or even cause damage or personal injury.
4. Purge the air network. The presence of water will damage the key (corrosion)
5. Clean the filter weekly.
6. The supply pressure must be increased to compensate for line losses (hose longer than
8 meters). The minimum pipe diameter must be 3/8" and the fittings must have the same
internal dimensions.
7. Keep the hose away from heat, oil and sharp objects. Check the hose for wear and ensure
that all connections are secure.

LUBRICATION

An automatic filter-regulator-lubricator (FRL) is recommended (Fig4) because it increases
the life of the tool... The lubricator must be regularly checked and filled with oil.
Its correct setting is made by placing a sheet of paper next to the exhaust and holding the
valve open for about 30 seconds. It is correctly adjusted when a slight oil stain accumulates
on the paper. Excessive amounts of oil should be avoided.
In the event that it becomes necessary to store the tool for an extended period of time, it
should provide for a larger amount of oil at that time. The tool must be operated for about 30
seconds to ensure that the oil has been distributed evenly throughout the tool. The tool must
be stored in a clean and dry environment.
- It is very important that the tool is properly lubricated by keeping the lubricator filled and
correctly adjusted. Without proper lubrication, the tool will not operate properly and parts will
wear prematurely.