Oven Installation - F.Bertazzoni KO30 PRO X Instructions D'installation

C. veRTICAl exHAUsT: OUTSIDE VENTILATION
1. Remove and save 2 screws from back edge and 3 screws
from the top center of the FAN COVER BRACKET. Remove
FAN COVER BRACKET by sliding it in the opposite direction
of the arrow on the FAN COVER BRACKET. See figure 9.
2. Lift HOOD FAN UNIT carefully and slip wires out of cavity.
See figure 10. CAUTION – Do not pull or stretch hood fan
wiring.
3. Rotate the HOOD FAN UNIT 90˚ so that the fan blade
openings are facing the top of the oven. See figure 11 (A).
Replace HOOD FAN UNIT into the oven. Be careful not to
pinch the lead wire between the inner bracket and the HOOD
FAN UNIT. Put the lead wire into Wire Box. See figure 11 (B).
Figure 9
Figure 10
(A) Rotate 90˚
Figure 11
4. Replace the FAN COVER BRACKET by sliding it into the
slits in the same direction as the arrow on the FAN COVER
BRACKET. Make sure the fan blades are visible through the
top openings in the oven before proceeding.
5. Attach the FAN COVER BRACKET to unit with the 2 screws
from back edge and 3 screws from the top center of the
FAN COVER BRACKET, which were removed in Step 1.
The HOOD FAN UNIT is now rotated for vertical exhaust
operation. Figure 12.
6. Attach the EXHAUST DAMPER ASSEMBLY to the fan cover
on the top of the outercase cabinet by sliding it into the slits
in the same direction as the arrow. Use 1 Tapping Screw 4
x 12 mm from the INSTALLATION HARDWARE and tighten
into place. Figure 13.
(B)
Figure 12
Figure 13

OveN INsTAllATION

THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT
REFERRING TO THE MOUNTING INSTRUCTIONS FOUND
ON WALL AND TOP CABINET TEMPLATES.
The next step is to read and follow mounting information on
wall and top cabinet templates. This oven must be attached to
at least one wall stud. See WALL CONSTRUCTION.
When done with templates, proceed to mounting scale plate
section.
MOUNTINg sCAle PlATe
1. The SCALE PLATES are used to help locate the mounting
plate. Attach 2 Scale Plates with tape (not included). See
Figure 14 and WALL TEMPLATE for locations. After securing
the mounting plate, remove and discard the Scale Plates.
Figure 14
E5
Model KO30 PRO X
Exhaust Damper Assembly
Scale Plates
Mounting Plate