Mounting Plate - F.Bertazzoni KO30 PRO X Instructions D'installation

INSTALLATION INSTRUCTIONS

MOUNTINg PlATe

1. Separate 4 TOGGLE BOLTS, packed in the INSTALLATION
HARDWARE, from the TOGGLE NUTS. Match 5/8" holes
(not in studs), drilled through WALL TEMPLATE into wall to
corresponding holes on MOUNTING PLATE. Insert Toggle
Bolts into matched openings on MOUNTING PLATE. Put
TOGGLE NUTS on TOGGLE BOLTS. Figure 15.
2. Position the MOUNTING PLATE with the TOGGLE BOLTS
attached at the wall location and insert TOGGLE NUTS and
Bolts through the holes in the wall with the TOGGLE NUTS
closed. Use Wood Screws to attach the MOUNTING PLATE
to studs. Figure 16.
NOTe – Before insertion, be sure you leave a space more
than the thickness of the wall between the MOUNTING
PLATE and the end of each of the TOGGLE NUTS (in the
closed position). If you do not leave enough space, the
TOGGLE NUT will not be able to open on the other side
of the wall. Also, once a TOGGLE NUT opens, it cannot
be withdrawn from the hole; therefore make sure all of the
Toggles are in the correct position before insertion.
3. Align the MOUNTING PLATE carefully and hold in position
while tightening TOGGLE BOLTS. Pull TOGGLE BOLT
toward you and turn clockwise to tighten. Figure 17.
Figure 15
Mounting Plate
Space more
than wall
thickness
Wall
Figure 16
Toggle Bolt
Figure 17
MOUNTINg OveN TO THe wAll
TwO PeOPle ARe ReCOMMeNded TO ATTACH THe
OveR THe RANge MICROwAve TO THe MOUNTINg
PlATe.
1. Thread the POWER SUPPLY CORD through the hole
made in the bottom of the top cabinet. Lift and tilt the oven
forward. Hook the back bottom of the oven to the bottom of
the MOUNTING PLATE. Lift the front of the oven up to the
bottom of the cabinet. Keep the POWER SUPPLY CORD
tight to avoid interference with mounting the oven flush with
the bottom of the cabinet. See figure 18.
2. Use the two TOP CABINET SCREWS and two FLAT
WASHERS, supplied in the INSTALLATION HARDWARE,
to attach the unit to the top cabinet. Tighten until the top
of the oven is right against the bottom of the cabinet. See
figure 19.
3. Attach the two Bottom Plate Screws saved from section
PREPARATION OF THE OVEN, Figure 4. Install the two
GREASE FILTERS. See figure 20.
Figure 18
E6