Ventilation System - F.Bertazzoni KO30 PRO X Instructions D'installation

INSTALLATION INSTRUCTIONS
PRePARATION OF THe OveN
Separate mounting plate from oven by removing two screws.
See illustration below. Save these screws for use in section
MOUNTING OVEN TO WALL, figure 23.
Figure 4
Back of Microwave

veNTIlATION sYsTeM

(PREPARING OVEN FOR INSTALLATION)
This over the range microwave is designed for adaptation
to three types of hood ventilation systems. Select the type
required for your installation.
ReCIRCUlATINg — NON-VENTED, DUCTLESS.
Follow installation procedure (A). Recirculating requires the
use of the Charcoal Filter, which has already been installed in
the oven.
HORIzONTAl exHAUsT — OUTSIDE VENTILATION.
Follow installation procedure (B).
veRTICAl exHAUsT — OUTSIDE VENTILATION.
Follow installation procedure (C).
A. ReCIRCUlATINg: NON-VENTED, DUCTLESS
OPERATION
• The unit is shipped assembled for recirculating.
• The EXHAUST DAMPER ASSEMBLY is not required for
recirculating operation.
B. HORIzONTAl exHAUsT: OUTSIDE VENTILATION
1. Remove 2 screws from back edge and 3 screws from the
top center of FAN COVER BRACKET. Save 2 screws to be
used later and discard remaining 3. Remove FAN COVER
BRACKET by sliding it in the opposite direction of the arrow
on the FAN COVER BRACKET. See figure 5.
2. Lift HOOD FAN UNIT carefully and slip wires out of cavity.
See figure 6. CAUTION – Do not pull or stretch hood fan
wiring.
3. Rotate the HOOD FAN UNIT 180˚ so that the fan blade
openings are facing the back of the oven. See Figure 7 (A).
Replace HOOD FAN UNIT into the oven. Be careful not to
pinch the wire and the HOOD FAN UNIT. See Figure 7 (B).
4. Put the wire back into the cavity. The FAN COVER BRACKET
and EXHAUST DAMPER ASSEMBLY are mounted to the
wall. Follow instructions on WALL TEMPLATE provided. See
Figure 8.
Mounting Plate
Figure 5
Figure 6
Figure 7
Figure 8
E4
Hood Fan Unit
(A) Rotate 180˚
(B)
Save fan cover bracket for future instructions.