FALMEC FISAB22B3SS Livret D'instructions page 10

Masquer les pouces Voir aussi pour FISAB22B3SS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

(In the 4-speed version the pushbutton + blinks. The fourth speed remains
on for a set duration of time. After 15 minutes the motor returns to the
third speed).
Mode pushbutton
Function: it turns hood motor on and off.
The function "desired speed" enables to start the motor at the speed that
was selected before the hood was last turned off.
Timer and 'filter clogged' alarm pushbutton
• This function allows the automatic turning off of the hood after running
for 15 minutes at the speed previously set (the pushbutton shows a flicker-
ing light).
• After about 30 hours of running the pushbutton indicates the need for
washing the metal filters (the pushbutton shows a solid red light). To dis-
able the alarm press the pushbutton for a few seconds until the red light
turns off. Then turn the hood off and on again to check that the alarm has
disappeared.
WARNING:
Install the hood away from sources of electromagnetic waves, as these
could affect the correct operation of the electronic system.
Maximum operating distance: 5 metres. The maximum operating distance
could be less than 5 metres in case of electromagnetic interference by
other equipment.
Light pushbutton on remote control: light on/off.
– and + pushbutton: increase/decrease speed (to start the motor press
either the + or the – pushbutton).
Timer pushbutton: see instructions below.
RADIO CONTROL OPERATING AT 433.92MHZ.
Technical characteristics:
Power supply
Trans. consumption 6mA
Antenna
Oscillating type
Working temp.
By pressing one of the keys the led will illuminate and indicate the tran-
smission of the code. If the led does not illuminate, the battery may requi-
re replacing.
Replacing the battery: open the rear cover and insert the battery respec-
ting the correct polarity.
ATTENTION! If the battery is replaced with one that is of the wrong type
there is the possibility of an explosion.
When discharging the battery, follow the respective regulations that are
currently in force.
The manufacturer
Falmec S.p.A. - Via dell'Artigianato, 42 - 31029 Vittorio Veneto (TV) ITALY
declares that this radio control conforms to all of the technical regulations
related to the product and within the application confines of the directive
1999/5/CE.
All of the necessary radio frequency tests have been performed.
8
3V lithium battery (type CR2032)
incorporated
SAW
-10°C to + 55°C

Publicité

Table des Matières
loading

Table des Matières