Teamtex MIRAGE EASY Mode D'emploi page 22

EN
2 - INSTALLING WITH VEHICLE'S SEAT BELT
1. Place your child in the car seat and make sure they
are sitting well back.
2. Thread the vehicle's seat belt through the belt guide
under the headrest and the belt guide under the armrest.
2.1. Pass the diagonal section of the seat belt through
the belt guide under the headrest.
2.2. Pass the lap section of the seat belt through the seat
belt guide under the armrest next to the seat belt buckle.
2.3. Ensure that no part of the seat belt has become
twisted or trapped and that the car seat's fabric cover is
not impeding the movement of correct fitting of the seat
belt.
3 - INSTALLING THE CHILD CAR SEAT
3. Ensure that the diagonal belt lies gently on the child's
shoulder and the lap belt is worn over the hips Tighten the
diagonal section of the seat belt by pulling it upwards until
there is no slack and the belt holds the child firmly in place.
4. To take the child out of the seat, simply unfasten the
seat belt and undo the shoulder belt guide.
4 -
USE THE ISOFIX SYSTEM IF YOUR VEHICLE'S
SEAT HAS ADDITIONAL ISOFIX ANCHOR
If your vehicule is equipped with isofix anchor points.
These should be used to obtain a more stable installation.
These cars will have plastic elements that guide the seat's
22
IM 2013,01 TORNADO_IFIX ins OK.indd 22
Isofix anchors into their correct positions. If your vehicle
does not have these guide elements, you can use the
plastic guides provided with the car seat.
Caution : When the seats of your car are equipped with
isofix anchor points, install your car seat using your
vehicle's ISOFIX anchor points ALWAYS and ONLY in
combination with the car's safety belts. See the vehicle list.
Match the back rest hook to the rear side of base from
lying position to upright position, to make sure the back
rest is fully matched into the base.
1. Place the car seat in the appropriate position on the
vehicle's seat, facing in the direction of travel.
2. Rotate the adjuster button in anti-clock wise direction,
and simultaneously pull the isofix connectors outwards
as far as it goes, make sure it cannot be push backwards.
3. Position the car seat facing forwards on the vehicle
seat with ISOFIX points.
4. Match the ISOFIX connectors to the vehicle's anchoring
point until hear a "click".
5. Rotate the adjuster button in anti-clock wise direction,
and simultaneously push the seat against the vehicle to
eliminate the gap between car seat and vehicle's seat.
ATTENTION ! Isofix connectors are an additional fitting
system for securing the car seat and not suitable for securing
a child. Child must always be secured by means of the car's
three-point safety Belt.
19/6/18 19:24