Fixing The Camera Bracket; Connecting The Camera - Extel WESV 82300 Guide D'installation Et D'utilisation

When installing the camera, check the good reception of the image on the monitor before the final
installation. For example ask another person to hold the camera in the area to control.
Move the monitor to different places of the house to control the good reception.
If you find some interference or other problems, please refer to the chapter "Maintenance".
b. Fixing the camera bracket
• Make sure that no element interferes with the installation.
• Search for a suitable place to fix the bracket.
• Screw the wall part with the supplied screws (use bushing
if necessary).
• Screw the camera on the bracket.
• Aim the camera at the desired direction and tighten the
side retaining screw.
c. Connecting the camera
• Connect the cord of the 7.5VDC adaptor to the "Power supply" plug of the camera.
• Plug the adaptor into a mains socket.
• Be sure to select an identical channel for the camera and for the monitor.
1. Selection of the channel of the camera
For the first use, the camera transmits on the channel No. 1.
Thus the monitor displays directly the camera No. 1 on the channel 1 (CH1)
2. Modifications of the transmission channels of the camera:
This setting must be necessary only if you want to change the transmission channel of the
camera (in case of a disturbed transmission for example). The video can be transmitted on 4
different channels. To use the channel selector switch, remove the cover located at the back
of the camera and then use a sharp object and select the desired channel in position CH1
CH2 CH3 CH4. Make sure to replace the rubber protections at the back of the camera.
GB5
All manuals and user guides at all-guides.com
CFI EXTEL WESV 82300 - 04/2012 - V1