Troubleshooting - Einhell Royal RLH 2540 FB Mode D'emploi

Anleitung RLH_2540_FB_SPK1:_
GB

10. Troubleshooting

Fault
The motor does not start Power failure
Material is not drawn in by the The shredding blade is running in
shredder reverse.
Material blockage in the filling
funnel
The shredding blade is jammed
The material is not shredded The counter blade is not set
properly correctly.
16
25.06.2007 9:21 Uhr
Cause Remedy
Check the mains lead, plug and
fuse.
Change the direction of rotation.
Change the direction of rotation
and pull the material out of the
funnel. Feed in thick branches
again so that the blade does not
immediately engage again in the
notches it previously cut.
Change the direction of rotation.
The blade will now release the
jammed material.
Adjust the counter blade. See
section 6.8 on how to do so.
Seite 16