Latch (Lower Anchors & Tether) Option - SafeGuard FlexPlus FlexSeat Mode D'emploi

LATCH (Lower Anchors & Tether) Option
For Use with Add-On Child Seats
WARNING! DEATH or SERIOUS INJURY can occur:
• Follow all instructions on the child restraint and in this manual. Failure to follow the
manufacturer's warnings for proper use of the child restraint system and LATCH attachments can
result in serious injury or death.
Location and Use of Lower LATCH Anchors
Some SafeGuard Bus Seats are equipped with lower LATCH
anchors for the attachment of add-on child seats. The lower
LATCH anchors (if available) are located in the seat gap
between the lower portion of the back seat and cushion.
Adding LATCH Anchors
Base FlexPlus Seats may be fitted with LATCH anchors if
not originally equipped. Contact your OEM Bus Dealer or
SafeGuard for further information on ordering LATCH anchors.
Location and Use of Tether Anchors
All SafeGuard FlexPlus Bus Seats are equipped with tether
anchors for add-on child seats.
Installing Tether
To attach an add-on child seat tether, route the tether on the
child seat over the top of the SafeGuard Bus Seat.
the tether and connect the snap hook to the nearest tether
anchor provision at the lower rear of the seat.
tether to a snug and tight fit by pulling on the free end of the
strap at the adjuster.
Tether anchor positions will vary dependent upon the seat type.
See below for examples.
30-in seat with lap belt
36/39-in seat with lap belt
B
D
30-in seat with
lap-shoulder belt
36/39-in seat with
lap-shoulder belt
Extend
C
D
Adjust the
8
Lower LATCH
Anchors
A
Back of
seat
Tether
Anchor
B
Child Seat
Tether
C
D
LATCH
Anchor
Pull to
tighten
Tether
Anchor