SafeGuard FlexPlus FlexSeat Mode D'emploi page 10

Seat Cushion Release
WARNING! DEATH or SERIOUS INJURY can occur:
• Follow all instructions on the child restraint and in this manual. Failure to follow the
manufacturer's warnings for proper use of the child restraint system and LATCH attachments can
result in serious injury or death.
Locating Seat Cushion Release Latch
Your SafeGuard Bus Seats are equipped with a cushion that
flips up for access underneath the seat. The cushion is held
in place by a latch underneath the seat as shown in Figure A.
While pulling the release latch back, lift up on the back of the
cushion to flip it up toward the front of the seat.
Post-Crash Inspection
Following any crash, you should have the bus structure, seat and restraint systems inspected by
a qualified technician.
To know if the SmartFrame Plus
deployed you should:
• Find the label on the top of the lower
seat frame (Fig. B).
• Stand directly over the seat and look
straight down to determine if the green
colored portion on the label is covered
by the frame section. (Fig. C)
• If it is covered you should replace the
seat including lap-shoulder belts.
• The SmartFrame Plus
independent of the inspection performed on the
rest of the seat or restraint system. Separate assessment
for all seat components required.
Refer to website safeguardseat.com/post-crash
for further inspection guidance.
has been
™
inspection is
™
9
Bottom of seat.
Pull toward back
to release latch.
A
B
C