Integrated Child Seat Option - SafeGuard FlexPlus FlexSeat Mode D'emploi

Integrated Child Seat Option

This child restraint system conforms to all applicable Federal Motor Vehicle Safety Standards.
WARNING! DEATH or SERIOUS INJURY can occur:
• Follow all instructions on the child restraint and in this manual. Failure to follow the manufacturer's
warnings for proper use of this child restraint system can result in serious injury or death.
• Use only with children who weigh between 22 and 85 pounds (10 and 39 kg) and whose height is
49 inches (124 cm) or less and who are at least 2 years of age.
• Top portion of the seat cushion must be folded under lower portion of seat cushion to form
seating surface for child.
• Adjust the belts provided with this child restraint snugly around your child.
ICS RESTRAINT REPLACEMENT:
service that requires replacement. However, the ICS and its components must be inspected
frequently (per instructions on Page 10) and replaced as needed. If you have any doubts about
the condition or function of the restraint, REPLACE IT. If any component of the ICS restraint requires
replacement, the entire restraint system must be replaced. If the vehicle is involved in a significant
accident, the entire ICS must be replaced.
1. Activate the restraint system by lowering the two-piece seat
cushion. Fold the top portion of the cushion under the bottom
portion to form a seating surface for the child.
seat belt buckles (if equipped) are NOT beneath the two-piece
cushion. Failure to fold the seat cushion under can result in
damage to the restraint and thus improper restraint of the child.
Open chest clip by squeezing middle tabs and pulling chest
clip apart.
Unbuckle harness buckle by pressing down on red release button.
To loosen harness, lift metal tab at top of seat 1 and pull down
on shoulder strap 2 to loosen strap.
Repeat with second shoulder strap.
2. Place the child in the restraint with the child's back flat
against the back of the bus seat cushion. Position shoulder
straps over the child's shoulders.
Buckle harness by inserting buckle tongues into harness
B
buckle 3 .
Listen for an audible click when each buckle tongue is fastened.
Check the buckle connection is secure by pulling on the
shoulder straps.
3. To tighten harness, pull down equally on top straps 4 on
both sides until the harness is snug around the child.
A snug strap should not allow any slack. It lies in a relatively
straight line without sagging. It does not press on the child's
flesh or push the child's body into an unnatural position.
4. Position each shoulder height adjuster 5 at or just above the
child's shoulder.
D
Fasten chest clip 6 by pushing both sides together.
Position chest clip at middle of the child's chest, at armpit level.
Be sure harness is snug and tight on child's thighs and chest.
The ICS restraint system does not have a designated
A
6
Be sure
A
1
2
B
4
C
C
D
Store instructions
behind the
removable seat
pad.
Two-Piece Seat Cushion
3
4
5
6