Parts Diagram - Salton STS 70 Mode D'emploi

PARTS DIAGRAM

A- Feet
B- Temperature control knob
C- Pilot light
D- Handles
E- Glass heating surface
OPERATING INSTRUCTIONS
1. Before first use unpack and remove all parts and packaging material from the carton.
2. Do not plug the power cord into the outlet before reading these instructions.
3. Ensure the temperature control knob is set to '0' before plugging the appliance into
the wall outlet.
4. Once ready to use, the temperature control knob must be turned clockwise to set the
desired temperature. If the temperature control knob is turned fully clockwise the hot
tray will be set to the maximum temperature of 125°C.
5. The indicator light should come on.
6. To lower the temperature turn the control knob anti-clockwise.
7. The indicator light will switch off as soon as the temperature is attained and will come
on again when the temperature goes below the set temperature. This will continue,
indicating the thermostatic control is operating to maintain the selected temperature.
8. If used outdoors, a higher temperature may be required.