Section 2 General Information And Setup; Know Your Power Washer; Emissions; Remove Contents From Carton - Generac Small Pro Manuel Du Propriétaire

Section 2 General Information and Setup

Know Your Power Washer

WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Read this manual
assembling and operating this unit. Save this
manual for future and immediate reference.
Replacement owner's manuals are available
at www.generac.com.

Emissions

The United States Environmental Protection
Agency (US EPA)
Resources Board
equipment certified to California standards)
requires this engine/equipment to comply with
exhaust and evaporative
standards. Locate the emissions compliance
decal on the engine to determine applicable
standards. See the
warranty for emissions warranty information.
Follow the maintenance specifications in this
manual to ensure the engine complies with
applicable emissions
duration of the product's life.

Remove Contents from Carton

1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
one each of the following:
• Main Unit
• Handle Assembly
• High-pressure Hose
• Siphon Tube & Filter
• Spray Gun
• Lance
• Oil
• Parts Bag (includes):
– Gun and Hose Hook Wireforms with
Screws, Nuts, and Allen Wrench
– Owner's Manual
– Owner's Registration Card
– Bag of Colored Nozzles
– Filter Screen* (*Factory installed on
axial cam pumps)
3. Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) with the unit
model and serial number for any missing
carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.
Owner's Manual for Power Washer
(000100a)
thoroughly before
(and California Air
(CARB), for engines/
emissions
included emissions
standards for

Assembly

Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Call Generac Customer Service at 1-888-
GENERAC
assembly issues or concerns. Please have
model and serial number available.
1. See
Figure
handle supports (B). Push in latch buttons
(C) and allow handle to slide into position.
Button will lock handle into place.
C
the
Figure 2-1. Insert Handle
2. See
Figure
with provided fasteners. Tighten securely.
Figure 2-2. Install Gun and Hose Hooks
3. See Figure
into spaces provided in handle.
Figure 2-3. Insert Nozzles
General Information and Setup
WARNING
(1-888-436-3722)
2-1. Place handle (A) onto
A
B
001528
2-2. Install gun and hose hooks
2-3. Insert and snap nozzles
001531
(000100a)
for any
001683
3