Worx WG268 Mode D'emploi page 9

OPERATING INSTRUCTIONS
WARNING! Do not use the product
without attaching the guard and
front handle.
1. GUARD ASSEMBLY
Insert the Safety Guard (7) into the slot as
illustrated in Fig. A; making sure it is securely
attached.
Use two screws to fix the guard securely.
2. FRONT HANDLE ASSEMBLY
The Front Handle (6) must be assembled
before use:
1) Take out the bolt from the Front Handle.
2) Attach the Front Handle to the housing.
Make sure the protruding marks on the
Front Handle fit perfectly into the matching
indentation on the housing. (See Fig. B&C)
3) Insert the locking bolt into the handle and
fully tighten the bolt. (See Fig. D)
4) Check whether handle is firmly secured, if
not retighten the locking bolt.
3. BEFORE USING YOUR CORDLESS
HEDGE TRIMMER
WARNING! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
NOTE: Your battery pack is UNCHARGED and
you must charge once before use.
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
4. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit.In a warm environment or
after heavy use, the battery pack may become
too hot to permit charging. Allow time for the
battery to cool down before recharging.
Cordless Hedge Trimmer
5. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. E)
Depress the Battery Pack Release Button (4) to
remove the Battery Pack (3) from your Hedge
Trimmer. After recharging, insert the Battery
Pack into trimmer's battery port. A simple push
and slight pressure will be sufficient. Check to
see if the battery is fully secured.
6. BATTERY STATUS LED'S (See Fig. F )
NOTE: The Status LED's will indicate the
battery condition when the button on the
battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
Press the button "POWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light ( ) is illuminated,
the battery charge is depleted.
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged, even
though the hedge trimmer may still be
capable of trimming hedge. Continuing
to operate your trimmer with the battery
in this discharged condition may reduce
the life and performance of your battery.
7. STARTING AND STOPPING
BEFORE STARTING YOUR HEDGE
TRIMMER
Remove Blade Sheath (9).
TO START YOUR HEDGE TRIMMER
Your Hedge Trimmer is equipped with both
Rear and Front Switch levers. Both switch
levers need to be pressed for the Hedge
Trimmer to start. Depress and hold the Front
Switch Lever (5) and press the Rear Switch
Lever (2) (See Fig. G).
TO STOP YOUR HEDGE TRIMMER
Move Hedge Trimmer away from cutting area
before stopping.
To stop, release one of the switch levers (See
Fig. H).
WARNING: If any parts are missing,
damaged or broken, do not operate
) are illuminated, the
EN
9