Troubleshooting; Fault Finding - Omcan Santos 50 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance
The grater (14) and to a lesser extent the basket assembly (5) can be considered as parts subject to wear.
For the machine to operate properly, it is recommended that a check is also made that the locking membrane
(15) is in good condition, in particular the absence of any signs of tearing. Also check that the rubber drive
sprockets are in good condition (17), in particular the absence of any signs of wrenching.
For all spare part orders (see references in the exploded view at the end of the manual), state the type, the
appliance serial number and the electrical specifications recorded under the appliance.
UPKEEP:
Neither a hose nor a pressure hose should be used for cleaning.
After use, clean the basket assembly, bowl, cover, pulp container, plunger and bowl centering device in
clean water or with a dish washing detergent product designed for this purpose. Then rinse and dry. Do not
use abrasive products or pads to clean the basket assembly.
The base and the motor unit trim should be cleaned with a soft, damp sponge and then dried.
CARE:
For easier cleaning, do not leave food remains to dry in the bowl (4), the basket assembly (5), the cover (2), or
the fruit plunger (3). It is recommended that all these parts of the machine are cleaned immediately after the
work is finished.

Troubleshooting

FAULT FINDING

First identify exactly why the machine stopped.
The machine will not start:
Check: the mains power supply and the condition of the power supply cord.
Check: the position of the juice bowl on the motor unit, the position of the cover on the juice bowl, and the
locking of the clamping handle on the cover.
The machine stops because the motor has overheated:
Put the On / Off button (11) to the 0 position, then remove the plug from the power supply socket and follow
the instructions in the section on «motor overheating safety feature».
The machine stops because of an overload:
See the section on «motor overload safety feature».
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

39494

Table des Matières