Porter&Charles CC76V Instructions D'utilisation Et D'installation page 12

Turning the appliance on / off .
If the appliance is in Stand-By-Mode, it is put in Operating-Mode by pressing
the On/Off button
successful operation.
On all zones a ´0` appears and all Decimal Point of the zones flashes.
If there is no operation within 10 sec, the display of all heaters will turn off.
If the displays are turned off, the zones
If is pressed more than 2 sec (in Operating-Mode), the appliance is
switched off and is set into the off mode again. The appliance can be turned
off by pressing
simultaneously..............................................................................
If there is residual heat remaining, this will be indicated by a flashing H in
the corresponding zone
Select Zone
If a single zone is chosen with the corresponding Active/Deactive zone
Button , the Decimal Point of the related Heater Display flashes. For the
selected zone , you can set the heat level between 1-9 by touching the
Heat Setting Buttons
The buttons must be pressed within 3 sec, otherwise the zone selection
is erased and heat setting dot will disappear (Decimal Point). If there is no
further operation within 10 sec, the zone
The heat setting can always be changed by pressing
level 1-9.
Each button operation or each display change is accompanied by a beep.
for at least 1 second. A beep indicates a
at any time; even if other buttons are pressed
Display.
or .
will be set to off.
falls back into off mode.
or between
.
.
.
8