Dry Filter; Troubleshooting - Tineco iFLOOR 3 Serie Mode D'emploi

Dirty Water Tank
1.When dirty water reaches the Max line, the
appliance will stop working and show a
reminder on the display.
2.Pull up the tank lid to empty the DWT. Use
the cleaning tool to remove remaining debris.
Rinse the inside of the DWT and place back
into the appliance.
Fig.D-3
Filter & Floater
1.If the filter and the floater have been blocked,
rinse with water.
2.Remove the filter from the tank lid, remove the
floater, and rinse both parts with water.
Fig.D-4

Dry Filter

Grasp recessed area on each side of the dry filter
and pull upward. Rinse under running water and
must be completely dry before recombining with
the lid of the DWT.
* A spare dry filter is provided with your
appliance for convenient replacement.
Fig.D-5
Brush Roller Self-cleaning
1.Place the appliance on the charging base after
use. When self-cleaning icon is blinking, press
the self-cleaning button and begin the process.
2.Once complete, the appliance will begin
charging. Clean the Dirty Water Tank after
cleaning completed.
Fig.D-6
Note:
• Ensure the charging base is plugged in and the
battery has enough power.
• Before self-cleaning cycle, please clean the
DWT and ensure the water level in the CWT
exceeds 40%.
Brush Roller Cover
1.Grab the front handle while pressing the
button and pull upward to remove.
Fig.D-7
2.Rinse with water.
Fig.D-8
3.When replacing, always latch the brush cover
into place to avoid leakage.
Fig.D-9
Brush Roller
1.Remove the brush roller by grabbing the brush
roller tab and pulling upward.
Fig.D-10
2.Remove the brush roller tab. Using the
cleaning tool, remove the hair and debris
wrapped around the roller and rinse with
water. Replace the brush roller back into the
accessory holder, and allow it to dry completely
before reinstalling.
Fig.D-11
3.Remove hair and debris from the brush roller
chamber and the opening with a tissue or a
damp cloth.
Fig.D-12
4.Replace the brush roller by inserting the brush
roller end into the right side of the holder,
then lock the pull tab into place by pressing
downward.
Fig.D-13

TROUBLESHOOTING

Problem
The appliance does
not turn on
Weak suction
Brush roller tangled
indicator blinking
CWT empty indicator
blinking
22
Solution
Charge the appliance
Restart after cooling
down
Clean the debris
channel and DWT
Install the dry filter or
clean and allow it to
dry completely
1. Remove blockages
2. Install brush roller
correctly
Refill CWT