Hayward ZRD Série Manuel D'installation page 10

Paragraph 11 – Flow Alarm
Programming
PROG
-­‐
-­‐
Alarms
Alarm Flow
Flow Off Off
Alarm Flow
On
-­‐
Alarm Flow - On
Signals
Alarms
Flow
Paragraph 12 – Level Alarm
Programming
PROG
-­‐
-­‐
Alarms
Level Stop
-­‐
Paragraph 13 – Flow Display Unit
Programming
PROG
-­‐
-­‐
Unit
Standard
-­‐
Paragraph 14 - Setting the Pause
Programming
PROG
Configuration
+
Paus
-­‐
N.Open
Hayward Flow Control
-­‐
+
-­‐
-­‐
+
6
ESC
-­‐ Off
Alarm Level
Stop -­‐
Alarm Flow
Alarm
ESC
Alarms
Level Alarm
-­‐
Unit
Standard <-
-­‐
+
Unit
L/h
-­‐
-­‐
+
-­‐
www.haywardflowcontrol.com
This makes it possible to activate (deactivate) the flow
sensor.
When activated (On), press the
request for the number of signals that the pump waits for
before an alarm is triggered. The number flashes when you
press the key, and you can then use the
to set the value. Confirm by pressing the
to return to the main menu
This makes it possible to set the pump when the level
sensor alarm is activated. In other words you can decide
whether to stop dosage (Stop) or simply activate the alarm
signal without stopping dosage.
Changes can be made by pressing the
the keys to set the alarm type. Confirm by
pressing the key. Press
menu
This makes it possible to set the dosage unit of
measurement on the display.
Changes can be made by pressing the
the keys to set the unit of measurement, choosing
between L/h (litres/hour),
(millilitres/minute) or standard (% or frequency, depending
on settings). Press
menu
The pump can be paused by remote input.
The factory setting is Normally Open.
Changes can be made by pressing the
using the keys to set the new value ( N. OPEN or
N. CLOSED).
Press to confirm and return to the main menu.
Operation
key to access the
Operation
key, then using
to return to the main
Operation
key, then using
Gph (Gallons/hour),
to confirm and return to the main
Operation
key, then
1-888-INDL (1-888-429-4635)
Pg. 8 of 11
keys
key. Press
ml/m
ZRDIOM