R
C
O
EMOTE
ONTROL
PERATION
Programming The Remote
The Universal Remote Control can be programmed to
operate many manufacturers' components, using the
component function buttons for VCR, DVD, AUX, RCVR,
DTV, CABLE or DBS. Follow the procedures for
programming your Remote Control with or without a code
for the component.
Device
Operates
TV
TV (Panasonic Only)
VCR
VCR (Preset)
DVD
DVD and CD (Preset)
DBS/
DBS & CBL (Preset)
CABLE
RCVR
Audio Receiver (Preset)
DTV
DTV (Panasonic Only)
Personal Video Recorders,
AUX
Cassette and VCR2
Note:
Determine the manufacturer of the component and look
in the table for the code.
Procedure
1. Confirm that the external component is plugged and
operating.
2. Turn the component off.
3. Press
and
OK
seconds. After 5 seconds, the illuminated mode
(component) buttons will begin to flash. Release the OK
and POWER buttons.
4. Press appropriate component button on the Remote
Control VCR, DVD (CD), DTV, RCVR, DBS/CBL or AUX
(PVR or VCR2). The component button will illuminate
steadily and all others will go out.
5. Enter the 3-digit component code using the Remote
Control numeric keypad (0 ~ 9 buttons). The component
button will blink twice.
6. Press the Remote Control
If the procedure was successful, the component will
turn on and the component key will blink twice and then
go out.
Note:
If the component does not operate with the Remote
Control, repeat steps 3 through 6 using another code.
(Some brands have multiple codes.) If an incorrect code
is entered, or if the procedure takes longer than 30
seconds, the programming will fail.
16
All manuals and user guides at all-guides.com
Default
Panasonic Code
Panasonic Code
DVD Panasonic Code
Panasonic DBS Code
Panasonic RCVR Code
Panasonic DTV Code
Panasonic Personal
Video Recorder Code
POWER
together, for at least 5
POWER
to test the component.
Programming Without A Code
This procedure searches all codes and is called the
"sequence method."
1. Confirm that the external component is plugged in and
on.
2. Turn the component off.
3. Press
and
OK
seconds. After 5 seconds, the illuminated mode
(component) buttons will begin to flash. Release the OK
and POWER buttons.
4. Press appropriate component button on the Remote
Control.
POWER
5. Press the
button to place the remote control into
the step and set mode.
6. Point the remote control towards the component.
7. Press VOL
(the mode key will blink three times), then
press the Remote Control
Continue this process until the proper code is found. If
the procedure was successful, the component will turn
on.
Note:
Each time you press the VOL
the component key blinks twice before pressing the
POWER button.
8. Once the device responds, press
code. The mode (component) button will blink twice.
Note:
It may take many attempts before the correct code
is found. If you miss a code, press
POWER
the
button to test the component.
Component Codes
The Universal Remote Control is capable of operating
many component brands after entering a code. Some
components may not operate because the codes are not
available due to limited memory. The Universal Remote
Control does not control all features found in each model.
Write the code numbers from tables in this space.
This will serve as a reference if you need to program
your Remote Control.
VCR
DVD
DBS
RECEIVER
AUX (PVR)
AUX (VCR2)
POWER
together, for at least 5
POWER
to test the component.
button, make sure that
to store the
OK
VOL, then press
DVD (CD)
CABLE