Corrective Action; Environmental Protection - BGS technic 3175 Mode D'emploi

ITEM
(1) Interference Blanker
(2) Motor Kit
(3) Gear Assembly Kit
(4) Yoke Block
(5) Plunger
(6) Grease Release Valve
(7) Filler Nipple
(8) Vent Valve
(9) Circuit Breaker
(10) Jiggle Switch
(11) Button
(12) Check Valve Kit
(13) Battery Capacity Display
TROUBLESHOOTING
CONDITION
Motor fails to run
Pressure relief valve opens to
discharge grease
Grease Gun fails to dispense
grease
Grease Gun continues to lose
prime
Battery fails to take a charge

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
DISPOSAL
Do not dispose battery in household waste.
Batteries should be disposed of in a responsible manner, they must be disposed at
appropriate collection point.
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment. Contact your local solid waste authority for
recycling information or give the product for disposal to BGS technic KG or to a electrical
appliances retailer.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
POSSIBLE CAUSE
• Battery needs recharging
• Faulty wiring to motor
• Blocked line
• Blocked bearing
• Blocked grease fitting
• Grease tube assembly is out of
grease
• Loss of prime
• Ball check (item # 12) is not
functioning. (See Figure 6)
• Air may be trapped in several
locations in container after bulk
filling
• Follower may be binding in
grease tube assembly
• Charger may not have power
• Battery may be bad
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Figure 6

CORRECTIVE ACTION

• Recharge battery
• Remove battery, disassemble
handle and check wiring for
loose connections
• Check lines, brazing and
grease fitting to remove or
clean obstructions
• Check that the container has
grease
• Repeat priming operation.
• Remove item #12, clean and
inspect ball seat area
• Empty grease tube assembly,
refill and repeat priming
operation
• Replace container (item # 10)
(See Figure 5)
• Check that the AC outlet or the
DC car socket has power.
• Replace battery
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed