Table des Matières
Publicité
7.
Install the Spout - Deck Mount
Coupling Assembly
Ensemble de couplage
Montaje de acoplamiento
Male copper connection
Connection en cuivre mâle
Conexión macho de cobre
12"
(30.5 cm)
Nut/Écrou/Tuerca
Fiber Washer
Rondelle en fibres
Arandela de fibra
Thread the tubes into the support plate.
Place a fiber washer and nut over the tubes, both above and below the deck.
Hand tighten the nuts.
Verify the top of the tube is flush with the surface of the intended finished deck
height.
Securely tighten the nuts with a wrench.
Solder a 1/2" male copper connection (not supplied) to the outside of a 12" (30.5
cm) section of each water supply line.
Apply thread sealant to each male copper connection.
Securely tighten the coupling assemblies to each male copper connection.
Connect the supply lines under the deck to the main water supply.
Insert the plastic pipe plugs into the coupling assemblies.
Turn on the water supply.
Check all connections for leaks. Adjust as needed.
Turn off the water supply, then remove and discard the plastic pipe plugs.
Finish the bath deck and surround.
1169172-2-A
All manuals and user guides at all-guides.com
Plug
Bouchon
Apply thread sealant.
Tapón
Appliquer un ruban
d'étanchéité pour filetage.
Solder together.
Aplique cinta selladora
Souder ensemble.
de roscas.
Suelde juntos.
Water Supply Tubing
Tuyauterie
d'alimentation d'eau.
Tubo de suministro
de agua.
18
Kohler Co.
Publicité
Table des Matières
