Table des Matières
Publicité
3.
Install the Riser Tubes - Freestanding
Setscrew
Vis de retenue
Tornillo de fijación
Gasket
Joint
Empaque
Riser tube
Tube d'élévation
Tubo vertical
Finished Floor
Sol fini
Piso acabado
Water Supply Tube
Tube d'alimentation d'eau
Tubo de suministro de agua
Thread the riser tubes down into the riser support until the riser tubes almost
bottom out. Do not completely tighten the riser tubes into the riser support.
NOTE: The distance from the surface of the finished floor to the top of the installed
coupling assemblies must be approximately 24-7/16" (62.1 cm).
Thread a coupling assembly onto each water supply connection, then tighten with
a wrench.
Install the plastic pipe plugs (provided) into each coupling assembly.
Turn on the main water supply.
Check for leaks. Adjust as needed.
Turn off the main water supply.
Remove and discard the plastic pipe plugs.
Thread the riser tubes out of the riser support, then thread the riser tubes up onto
the coupling assemblies until hand-tight.
Slide an escutcheon with gasket (supplied in the bath filler hardware pack) over
each riser tube and against the surface of the finished floor. The setscrew holes on
each escutcheon should face toward the bath.
Secure each escutcheon in place with a small setscrew.
Installer les tubes élévateurs - Autoportante
Visser les tubes élévateurs dans le support élévateur jusqu'au bout. Ne pas
complètement serrer les tubes élévateurs dans le support de l'élévateur.
1169172-2-A
All manuals and user guides at all-guides.com
Escutcheon
Applique
Chapetón
Riser tube
Tube d'élévation
Tubo vertical
Plastic Pipe Plug
Bouchon à tuyau en plastique
Tapón de tubo de plástico
24-7/16"
(62.1 cm)
Coupling Assembly
Ensemble de couplage
Montaje de acoplamiento
10
Kohler Co.
Publicité
Table des Matières
