CLAS OC 9123 Guide Rapide page 8

OC 9123
REAR PARKING SENSOR PUNCH TOOL KIT TOYOTA (5 PCS)
INSTRUCTIONS
Always adhere to the vehicle manufacturer's recommendations and repair instructions!
• As a rule, the position of the sensors is marked by the manufacturer with markings on the inside of the
bumpers (Fig.1). The supplied assembly tool set may contain a template suitable for the vehicle and/or the
bumper.
• Use a Ø10 mm drill to drill a hole for each marking on the bumper.
Place the drill exactly in the middle of the marking and drill from the inside to the outside (Fig.2).
1
• Select the bushing suitable for the hole and insert it on the threaded pin with bearing. The opening of the
matrix should face the direction opposite the bearing (Fig.3).
• Insert the drive unit with the threaded part into the hole previously drilled in the bumper (Fig.4).
3
2
4