Bosch sensixx B15L Notice D'utilisation page 12

en
that have to be ironed at the lowest tempera- -
tures
• If you are not sure what the garment is made of
then begin ironing at a low temperature and decide
on the right temperature by ironing a small section
not usually seen when worn.
F) Ironing with Steam
1. Make sure that there is enough water in the
appliance.
2. Turn the temperature dial (12) to the steam
position between •• and MAX.
(If a too low temperature has been selected
and the steam function is used water may
leak from the soleplate)
3. Place the iron on the iron stand (16).
4. Insert the mains plug into the wall socket.
5. Turn the main switch (4) to steam position
6. The "steam ready" pilot light (1) will be continuo
usly on after the boiler/iron reaches the desired
temperature.
7. Set the desired amount of steam with the vari-
able steam control dial (3).
8. Hold the steam release button (11) for steam
production during ironing in horizontal position
or freshen up garments in vertical position.
For models with cork handle only:
For permanent steam press the lock button (14)
and slide it backwards until it locks. To switch
off the permanent steam, slide the lock button
forward.
Note:
• The "Water empty" pilot light (2) will flash when
the water tank is empty or when the water level
is too low. Refill the tank if the steam function is
needed. (see D)
Important
• The steam hose may get hot if you are ironing
for a long time.
• While the steam release button is pressed the
appliance may produce a pumping sound. This
is normal, indicating that water is pumped into
the steam boiler inside the housing.
12
All manuals and user guides at all-guides.com
G) Vertical steam feature
1. Set the temperature dial (12) to the positio
••• or MAX.
2. You can steam curtains and hanging garments
by holding the iron in a vertical position an
pressing the steam release button.(11)
3. Operate the iron at a distance of 10 to 20 cm.
Caution:
The steam is very hot. Never direct the steam
towards a person.
H) Ironing without steam
• Turn the main switch (4) to the position
to iron without steam. The boiler will not b
activated.
• Ironing without steam is also possible in the
position if the steam release button (11) is no
.
pushed. In this case the boiler is activated.
- -
Additional features
-
(Depending on the model)
I ) Automatic cable rewind
TDS1536
For easy storage, your ironing station is fitted wi
automatic cable rewind.
- Pull the plug and extract the length of cable
required. The cable locks automatically
- Do not try to extract the cable beyond the red
mark at the end of the cable
- To wind up the cable, press the rewind button
J) Fabric-protection
soleplate cover
The fabric-protection soleplate cover is used fo
steam-ironing delicate garments at maximum
temperature without damaging them. Use of th
soleplate cover also does away with the need for
a cloth to prevent shine on dark materials.
It is advisable to first iron a small section on th
inside of the garment to see if it is suitable.