Electrical Safety; Special Safety Instructions For Woodworking Machines - HOLZMANN MASCHINEN TFM610V Manuel D'utilisation


Choose a level, vibration-free, non-slip surface for the installation location.

Ensure sufficient space around the machine!

Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects!

Only use perfect tools that are free of cracks and other defects (e.g. deformations).

Remove setting tools from the machine before switching on.

Keep the area around the machine free of obstacles (e.g. dust, chips, cut workpiece parts
etc.).

Check the strength of the machine connections before each use.

Never leave the running machine unattended. If necessary, stop the machine before
leaving.

The machine may only be operated, serviced or repaired by persons who are familiar with
it and who have been informed of the dangers arising in the course of this work.

Ensure that unauthorised persons maintain an appropriate safety distance from the
machine and, in particular, keep children away from the machine..

Wear suitable protective equipment (eye protection, dust mask, respiratory protection, ear
protection, gloves when handling tools) as well as close-fitting work protective clothing -
never wear loose clothing, ties, jewellery, etc. - danger of being drawn in!

Work with gloves on rotating parts is not permitted!

Hide long hair under hair protection.

Do not remove any sections or other parts of the workpiece from the cutting area while
the machine is running!

Do not remove splinters and chips by hand! Use a sliding stick for this purpose!

Always work with care and the necessary caution and never use excessive force.

Do not overload the machine!

Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!

Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).

Do not smoke in the immediate vicinity of the machine (fire hazard)!

Make sure that the ON/OFF switch is in the "OFF" position before connecting the machine
to the power source.

Do not use the machine if it cannot be switched on and off with the ON/OFF switch.

Make sure that the device is earthed.

Only use suitable extension cords.

Always shut down the machine before carrying out any conversion, adjustment,
measuring, cleaning, maintenance or repair work and always disconnect it from the power
supply for maintenance or repair work. Before starting any work on the machine, wait until
all tools or machine parts have come to a complete standstill and secure the machine
against unintentional restarting.

12.4 Electrical Safety


Make sure that the machine is earthed.

Only use suitable extension cords.

A damaged or tangled cable increases the risk of electric shock. Handle the cable with
care. Never use the cable to carry, pull or disconnect the power tool. Keep the cable away
from heat, oil, sharp edges or moving parts.

Proper plugs and sockets reduce the risk of electric shock.

Water entry into machine increases the risk of electric shock. Do not expose machine to
rain or moisture.

The machine may only be used in humid environments if the power source is protected by
a residual current circuit breaker.

Do not use the power tool if it cannot be turned on and off with the ON/OFF switch.

12.5 Special Safety Instructions for Woodworking machines


During operation of the machine wood dust is generated. Therefore, connect the machine
to a suitable dust collection system for dust and chips during installation!

Always switch on the dust collection system before you start machining the workpiece!
When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must

comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-
3:2013;

Excessive noise can cause hearing damage and temporary or permanent hearing loss.
Wear hearing protection certified to health and safety regulations to limit noise exposure.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
SAFETY
23
TFM610V