Table des Matières
Publicité
en
en
20 | EL–52425 | Installation
4.3
End stop
¶
Tighten the screws hand-tight.
1
1
Fig. 4:
End stop
1 2 x M5 x 16
4.4
Tape measure mounting
Fig. 5:
Tape measure mounting
X 0 mm - 300 mm
1. Attach the tape measure mounting at a height of
0 mm - 300 mm (measured from the base plate) or
in accordance with specific vehicle manufacture
requirements.
2. Tighten the screws hand-tight.
|
1 690 386 081
2018-02-22
All manuals and user guides at all-guides.com
4.5
i
1. Position the mount for the precision holder on the
2. Fasten the mount for the precision holder to a maxi-
!
Fig. 6:
Mount for precision holder
To simplify assembly, remove the precision holder.
On completion of assembly of the "Mount for the
precision holder", reattach the precision holder.
threaded bolts of the slide.
mum of 5 Nm using self-locking hex nuts.
A greater torque may damage the threaded bolts.
Fastening the mount for the precision holder
Robert Bosch GmbH
Publicité
Table des Matières
