Connecting Disposer To Mounting Assembly - Westinghouse 1314311 Manuel De L'utilisateur

Installation (continued)
CONNECTING THE DISPOSER TO THE
MOUNTING ASSEMBLY
- Adjust the disposer position to make the elbow line up with the
trap (see Fig . 11) .
- The disposer must be installed so that the reset button is
readily accessible (see Fig . 12) .
- Make sure the cushion mount is properly in place . Line up
the disposer under the mounting assembly . Lift and guide the
disposer so that all three tabs of the bottom supporting ring
engage the steps of the top supporting ring . Turn the bottom
supporting ring counter-clockwise until it is fully engaged and
the tool mount comes in contact with the top supporting ring .
Insert a screw driver into the tool mount for added leverage, if
needed (see Fig 13a) .
If you are unable to fully engage the bottom supporting ring,
release and lower the waste disposer (see Fig 13b) .
All manuals and user guides at all-guides.com
supporting
Bottom
supporting
ring
8
Fig . 12
Sink
Mounting
Assembly
Top
Step
ring
Cushion Mount
Tab
Tool
Mount
Fig.13
Fig. 13b
Fig. 11
Elbow
Trap
Disposer body
Reset Button
Sink
Tool Mount
Fig.13a