Attaching Discharge Elbow; Removing Knockout Plug - Westinghouse 1314311 Manuel De L'utilisateur

Installation (continued)
If at any time the bottom supporting ring becomes disengaged
from the body of the waste disposer, then:
1 . Align the slot in the bottom supporting ring with tab on the
waste disposer body .
2 . Lower the bottom supporting ring and make the slot fit in the
tab .
3 . Turn the bottom supporting ring counter clockwise to secure it
in place .

ATTACHING DISCHARGE ELBOW

- Make sure the elbow gasket is attached to the discharge elbow
correctly (see Fig . 9a) .
- Connect the discharge elbow to the disposer
(see Fig . 9) .

REMOVING KNOCKOUT PLUG

(SKIP THIS STEP IF YOU DO NOT HAVE A DISHWASHER)
- Using a blunt instrument (steel punch or wooden dowel),
knock out the entire plug (see Fig . 10) . Do not use a
screwdriver or sharp instrument . When the knockout plug falls
into the disposer, you may remove it, or grind it up when the
disposer is being used . This will not damage the disposer in
any way, but may take some time to grind .
All manuals and user guides at all-guides.com
Slot
Tab
7
Please contact customer.service@conglomkb.com or 1-877-333-0098 for further assistance .
Elbow Gasket
Groove
Fig . 9a
Discharge Elbow
Fig . 9
Knockout
Plug
Wood or
Metal Dowel
Fig . 10
CONGLOMKB .COM