Assembling The Accessories; Plastic Basket; Watch Stand; Electrical Connection - CASO DESIGN 1510 Mode D'emploi Original

12.6 Assembling the accessories

12.6.1 CD-rack
12.6.2

Plastic Basket

12.6.3

Watch Stand

12.7 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device
If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
Put the disks (CD, VCD, DVD) into the disk holder as shown in
the picture (two disks can be cleaned at one time). Then put the
holder into the cleaning tank
When a small item has to be cleaned, put the item into the plastic
basket, then put the basket into the tank. In this way, frictions
between the item and the tank can be reduced.
Please pay attention, the plastic basket is only for cleaning small
items, because it absorbs about 30% of ultrasonic energy, and
reduces the cleaning result. In this case, when using the plastic
basket, please refer to the instruction of "Enhanced Cleaning" in
this manual.
Do not put a watch (of water proofing capability less than 30
meters) into the tank directly. Water may penetrate into the watch
and cause severe damages. It is recommended to use the watch
stand for watchband cleaning by simply immerse the watchband
into the water while keeping the watch itself on top of the water.
Similar to plastic basket, the watch stand absorbs ultrasonic
energy. When the watch stand is used, use "Enhanced
Cleaning".
32