GLÄSS NonSoloDoccia Home Notice D'installation, Utilisation & Maintenance page 15

EN
Limescale can be removed from water jet
nozzles simply by rubbing.
TROUBLESHOOTING
In the event of abnormalities run the following checklist.
All electrical connection
performed by an electrical installation technician.
If there is no response from the wall controls, check that:
- The switch is on.
- The appliance is powered. Check that the domestic power
supply is working by testing other electrical household
appliances which you know are operating correctly.
All hydraulic connection
performed by a hydraulic installation technician.
If the water is slow to drain away, check that the drain is not
blocked.
If the product does not dispense water, check that:
- There is water in the main pipe.
- The diverter is correctly set.
- There are no impurity into the pipes that prevent normal
water fl ow.
If the above operations do not solve the problem, contact your
nearest service centre or the company.
THERMOSTATIC MIXER
During testing, the thermostatic mixer is set so that the
mechanical stop point (button on lower part of knob) is at 38°C.
WARNING
If hot and cold water pressure in the piping system is not uniform,
further setting may be necessary.
The appliance will not operate correctly if the system pressure
is below 120k Pa (1,2 bars). If the water mains pressure is over
250k Pa (2,5 bars), a pressure reducer must be fi tted upstream
of the system.
We recommend instal-ling resin fi lter (30/40 litres/minute) on
the delivery line in order to prevent foreign bodies etering the
circuit and damaging the mechanical parts of the mixer.
SETTING
checkup must be
checkup must be
WARNING
16
38°
FUNCTIONING
The thermostatic mixer has a safety block at 38°. To reach a
higer temperature press the button and turn the handle (A)
anticlockwise.
• turn the cock handle ( B) and place the central ax on the desired
function: Shower head / Large head / waterfall.
• Turn the handle (A) to adjust the temperature.
B
38°
-
38°
A
FUNCTIONING
STEAM BATH FUNCTION
Before starting the steam bath function, check that the cabine
doors are closed and that there isn't an excessive steam
38°
+38° -38°
38°
38°
+38°
B
2
1
losses.