Lindy 43116 Manuel Utilisateur page 3

User Manual
 Accepts 1.8/2.5/3.5" HDD/SSDs with 22 pin SATA combo interface. For Micro
SATA please use LINDY adapter No. 33502.

Supports auto spin down after being idle for 5 minutes

Compatible with Windows, Mac OS, Linux; Software support only for Windows
computers
Installation

Connect the power supply

For normal docking station operation connect the Docking Station to your
computer with the USB 3.0 cable provided

Insert the HDDs into the docking station and press the power switch ON
 Wait until the drivers are loaded by the computers operating system (OS) – you
should then see the drives in the file manager program

Before detaching the HDDs make sure the data transfer processes is complete
and that the activity light is not lit.
Hardware Clone Function
Make sure that no data is stored on the target hard drive – otherwise you will completely
overwrite it during the clone process!
 If you want to clone HDDs, do not connect the Docking Station to your
computer
 The target HDD must be of equal or larger capacity than the source HDD
 Make sure target HDD is empty and not partitioned (i.e. by using, your
operating system disk management utility)
Install the source and target HDDs into the appropriately labelled bay (Source

and Target)
 Press the power switch ON
Press the Clone button until the blue LED starts to flash, then press the Clone

button again. The Clone process will start and the 25% LED will flash. The per
cent status changes as clone progresses. The 100% LED flashes once the
clone process has ended. Do not switch OFF or unplug the HDDs during the
cloning process!
Software Clone Function
Make sure that no data is stored on the target hard drive – otherwise you will completely
overwrite it during the clone process!
Install the software CloneDrive2 from the included CD. When the installation is
complete, you will find the corresponding icon in the taskbar.
All manuals and user guides at all-guides.com
English