Warnings and Recommendations
WARNING: To uphold compliance with network protection standards, all active cellular devices
must maintain at least 6 feet of separation distance from Panel and Dome antennas.
WARNING: Connecting the Signal Booster directly to the cell phone with use of an adapter will
damage the cell phone.
WARNING: Use only the power supply provided in this package. Use of a non-Wilson Electronics
product may damage your equipment.
WARNING: The Signal Booster unit is designed for use in an indoor, temperature-controlled
environment (less than 150 degrees Fahrenheit). It is not intended for use in attics or
similar locations subject to temperatures in excess of that range.
WARNING: Warning: The Outside Antenna must be installed no higher than 10 meters (32'9")
above ground.
WARNING: Take care to ensure that neither you nor the pole comes near any power lines during
installation.
RF SAFETY WARNING: Any antenna used with this device must be located at least
8 inches from all persons.
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and
have your provider's consent. Most wireless providers consent to the use of signal
boosters. Some providers may not consent to the use of this device on their network. If
you are unsure, contact your provider.
In Canada, BEFORE USE you must meet all requirements set out in ISED CPC-2-1-05.
You MUST operate this device with approved antennas and cables as specifi ed by the
manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from (i.e., MUST
NOT be installed within 20 cm of) any person.
You MUST cease operating this device immediately if requested by the FCC (or ISED in
Canada) or licensed wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls
served by using this device.
This device may be operated ONLY in a fi xed location (i.e..may operate in a fi xed loca-
tion only) for in-building use.
Note: Dome Antennas are not recommended with these Signal Booster(s).
Note: For a complete list of antennas and cables approved for use with these boosters see
pages 13 & 14.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by Wilson Electronics could void the authority to
operate this equipment.
Contact Wilson Electronics Customer Support Team with any questions at
866-294-1660 or email: tech@wilsonelectronics.com
12