Customer Assistance - Lutron DIVA DVTV Directives D'installation

0-10 v gradateur avec pré-réglage
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Wiring
The total low-voltage wiring for this unit should not exceed
500 ft (152 m) with 20 AWG (0.50 mm
wiring runs, or where excessive electrical noise exists, shielded cable
or conduit is required. A maximum load of 30 mA of current can be
connected to the dimming wires (Purple, Pink) and a maximum
load of 100 mA of current can be connected to the switch wires
(Blue, Red, Red/White) of one control. Install in accordance with all
local and national electrical codes.
NOTICE: LUTRON IS NOT LIABLE FOR DAMAGE DUE TO MISWIRING
0-10 VOLT CONTROL SIGNAL WIRES WITH LINE VOLTAGE.
WARNING: SHOCK HAZARD. COULD RESULT IN SERIOUS INJURY
OR DEATH. DO NOT RUN CLASS 2 WIRES AND LINE VOLTAGE
CONDUCTORS TOGETHER IN THE SAME CONDUIT.
The low-voltage ballast control can be wired two ways: Dimming Only
or ON/OFF and Dimming. Use the appropriate wiring diagram.
Wiring Without Relay
No Power Switching
Connect the control as shown in Figure B2. Changing the slider position
will alter light intensity. Toggling the switch will switch between the
preset slider value and the minimum light intensity of the ballast or
driver. Note that on some ballasts and drivers this minimum light
intensity will not be OFF.
Dimming Only Wiring
Power wiring not shown—see lighting device for wiring
Figure B1:
Pink (-)
Purple (+)
Red
Blue
Red/
White
Dimming Only Wallbox Wiring
Figure B2:
Purple (+)
Pink (-)
Red
Red/White
Note: Wire locations will vary. Reference wires by color not location
* This wire/terminal may be gray in retrofit applications.
2
) wire. For long low-voltage
2
0-10 V Ballast/Driver
0-10 V Ballast/Driver
Purple (+)
Pink * (-)
Ground
Blue
Green
Dimming With ON/OFF Control via Relay
Connect the control as shown in Figure C2. Do not install the Relay in
the same wallbox as the low-voltage control. Refer to the wiring sheet
included with the Relay for more information.
Dimming With ON/OFF Control
Wiring Diagram Using Relay
Figure C1:
Class 2 Only
Pink (-)
Purple (+)
Red
Blue
Red /
White
PP-120H /
Ground
Red
230H /
Blue
277H /
Black
347H
Ground
* This wire/terminal may be gray on older products or in retrofit applications.
Dimming With ON/OFF Control Wallbox Wiring
Figure C2:
Purple (+)
Pink (-)
Red
Blue
Red / White
Note: Wire locations will vary. Reference wires by color not location.
* This wire/terminal may be gray in retrofit applications.

Customer Assistance

For questions concerning the installation or operation of this product, call
Customer Assistance. Please provide exact model number when calling.
U.S.A. and Canada: 1.844.LUTRON1; Fax +1.610.282.6311
Mexico: 1.888.235.2910
Other countries: +1.610.282.3800
www.lutron.com/support
Warranty
Lutron will, at its option, repair or replace any unit that is defective in materials or manufacture within one
year after purchase. For warranty service, return unit to place of purchase or mail to LUTRON at 7200 Suter
Road, Coopersburg, PA 18036-1299, postage prepaid.
This warranty is in lieu of all other warranties, express or implied, and the implied warranty of
merchantability is limited to one year from purchase. This warranty does not cover the cost of
installation, removal, or reinstallation, or damage resulting from misuse, abuse, or damage resulting
from improper wiring or installation.
This warranty gives you specific legal rights, and you may also have other rights which vary from state
to state. Some states do not allow the exclusion or limitation of incidental or consequential damages or
limitations on how long an implied warranty may last, so the above limitations may not apply to you.
Lutron, Diva and Eco-10 are trademarks or registered trademarks of Lutron Electronics Co., Inc. in the US
and/or other countries.
All other product names, logos, and brands are property of their respective owners.
© 2010-2020 Lutron Electronics Co., Inc.
Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036-1299 U.S.A.
Pink * (-)
Purple (+)
0-10 V Ballast/Driver
Pink * (-)
0-10 V Ballast/Driver
Purple (+)
Red
Red
White
Neutral
Black
Line / Hot 120 / 230 / 277 / 347 V~ 50 / 60 Hz
Purple (+)
Pink * (-)
Ground
Red
Blue
Green
White
Black
White
Black

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Diva dvsctv

Table des Matières