Electrolux EFC9140 Mode D'emploi page 37

USE
The hood can be switched on pushing directly onto the requested speed without firstly
having to select 0/1 button
Basic function
Button
Dual Function
Press briefly to turn the lighting system on and off.
Press and hold the button for 2 seconds to activate the lighting system in
L
"courtesy light" mode. The lights are lit at a reduced power of approximately
5W. This function can be disabled by pressing the button once again for 2
seconds or by pressing it briefly to switch to normal lighting mode.
Turns the motor off from whatever speed it is set to.
T1
Press and hold the button for 3 seconds with all the loads turned off (Motor
and Lights), to turn the Activated Charcoal Filter alarm on/off.
T2
Turns the motor on at speed one.
When pressed briefly, turns the motor on at speed two.
Press and hold the button for approximately 2" to turn the Delay function
on and off, that is to say to turn the appliance off after a 20 minute delay.
T3
Suitable to complete elimination of residual odours. Can be activated
from the OFF position and from speeds 1, 2, 3. Cannot be activated with
Intensive speed On.
T4
Turns the motor on at speed three.
Turns the motor On and Off at Intensive speed for a timed period of 5
minutes. At the end of the 5 minutes the appliance will automatically return
T5
to the speed that was set before. If the appliance was turned off at the time
of activation, at the end of the 5 minutes the system will return to speed one.
Press and hold for 4 seconds to reset the filter alarm indicator, shown by
F
flashing of button T1. This procedure can only be carried out with the motor
off.
L T1 T2 T3 T4 T5 F
Indicator lights
Button off Lights off
Button lit Lights on
Button lit Courtesy light on
Button lit Motor active
Motor inactive
Button flashes twice F – Alarm On.
Button flashes once F – Alarm Off.
Button on
Button on Speed two on
Buttons flashing
(T1+T2 or T3 Delay functionActive
or T4)
Button on
Button on
Signals the Metal Grease Filter
saturation alarm, indicating that it
is necessary to wash the filters.
Button on
The alarm is triggered after the
Hood has been in operation for
100 working hours.
When this is activated, it signals
the Activated Charcoal Filter
saturation alarm, indicating
that the filter must be changed;
the Metal Grease Filters must
Button flashing
also be washed. The Activated
Charcoal Filter saturation alarm
comes into operation after the
Hood has been working for 200
hours.
ENGLISH 37