Solo 880-12 Instructions D'emploi page 59

x Push on outer mounting flange (c) so that the curved side points southwards, i.e. away from the cut-off
wheel.
x Push on wheel (b) and turn in cut-off wheel attachment screw (11).
x Insert blocking pin (a) entirely into the blocking opening (12) and firmly tighten (30 Nm [22.1 ft·lbf]) the
cut-off wheel attachment screw (11).
Securely hold the power tool at the top handle with one hand and push it firmly onto the ground.
x Remove the blocking pin (a).
5.2 Installing cut-off wheels with 1" inner bore
The power tool's spindle is designed for cut-off wheels with an inner bore of 20 mm.
For proper installation of cut-off wheels with a 1" inner bore, the spindle adapter disk is required that
is included with the delivery of the power tool.
The spindle adapter disk ensures correct fit of the 1" cut-off wheel on the spindle.
e
5.3 Removing the cut-off wheel
x For cut-off wheel removal, the power tool must be put securely on the ground. Securely hold the power
tool at the top handle with the left hand and push it firmly onto the ground. Î Chap. 5.4, page 18
x Insert blocking pin (a) entirely into the cut-off wheel blocking opening (12) to block the spindle.
Unscrew cut-off wheel attachment screw (11).
Remove wheel (b) and outer mounting flange (c) (also see chap. 5.1).
x Remove cut-off wheel from the spindle. For cut-off wheels with a 1" inner bore, the spindle adapter disk
also must be removed from the spindle.
x Put the outer mounting flange back onto the spindle so that the curved side points outward.
x Put on wheel (b) and turn in the cut-off wheel attachment screw (11) again. Î Chap. 5.1.
x Insert blocking pin (a) entirely into the blocking opening (12) and firmly tighten (30 Nm [22.1 ft·lbf]) the
cut-off wheel attachment screw (11) again.
Securely hold the power tool at the top handle with one hand and push it firmly onto the ground.
x Remove the blocking pin (a).
All manuals and user guides at all-guides.com
f
x Installation of cut-off wheels with 1" inner bore
takes place according to chap. 5.1 as of page 16.
x After applying the cut-off wheel on the spindle,
however, the spindle adapter disk (e) must be
put on the spindle (f) additionally.
x Put the spindle adapter disk (e) onto the spindle
so that it inserts between spindle and inner bore
of the cut-off wheel.
The support area of the spindle adapter disk
must point outwards in the installed condition,
i.e. away from the spindle.
The correct orientation of the spindle adapter
disk is mandatory to directly connect the plane
inner area to of the outer mounting flange to the
cut-off wheel. Only this warrants secure
attachment of the cut-off wheel.
x Application of the outer mounting flange and all
following steps must be performed again
according to chap. 5.1.
Preparing for use
ENGLISH 17