YORKVILLE elite LS2100P Manuel D'utilisateur page 4

5. LINK Jacks
The Link jacks are
set up to make it
easy to hook up
your LS2100P to
any audio system
with a minimum of
hassles. SInce all
of the Link jacks
are connected
in parallel, you
can use them to
daisy-chain other LS2100Ps or full range
enclosures.
Note: the Mono Blend Input is intended
for Line Level signals only!
For normal operation, connect the LS2100P
just like an ordinary speaker along with the full
range enclosures. Set the Input Level switch
to Speaker if the signal is coming directly from
a power amplifier, 'powered' mixer, or other
powered source. If the LS2100P is receiving the
signal from a non-powered mixer, a line level
signal processor (as in an equalizer) or another
line-level source, set the input switch to Line.
The LS2100P may be plugged in before or
after the full range enclosure. The LS2100P
does not alter the signal to the daisy chained
enclosures and will not draw any power from
the host amplifier/processor driving them.
Also, note that an external crossover is not
necessary when using the LS2100P.
As well as accommodating full range
enclosures, the Link jacks allow many LS2100Ps
to be connected in a string (parallel). There
AT HIGH POWER LEVELS WHEN THE LIMITER IS OPERATING INCREASING THE SUBWOOFER LEVEL CONTROL WILL NOT
INCREASE THE OUTPUT. DO NOT INCREASE SETTING WHILE OPERATING AT HIGH LEVELS.
Note: The LS2100P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support
many of our élite enclosures. The support tube can be adjusted up to it's full 5-foot 4-inch extension safely as long
as the LS2100P is not inclined more than 10° (10-degrees). Maximum pole extension for mounted enclosures is
48-inches for 85 lb. enclosures and 60-inches for enclosures that are less then 55 lbs.
LS2100P
SHAPE
LEVEL
POWER
LIMIT
CLIP
dB 12 LOUD
INPUT
SPKR
LINE
MONO BLEND INPUT INPUT
WARNING: Larger or heavier cabinets should not be used!
2
HI FREQ.
ROLLOFF
DEEP 90 Hz 150
INPUT
OUTPUT OUTPUT
level signal to the system without externally
summing the two signals (e.g. Left and
Right). This is helpful when you are adding
a single LS2100P to a stereo system. By
using this input for your secondary signal,
it is blended internally with the Link input
but isolated to prevent interaction of those
signals.
7. Protection
The LS2100P has circuitry to prevent clipping,
over current and over excursion. At high levels
the limiter will limit the gain of the LS2100P and
hence if the user attempts to set the subwoofer
level control at a high level, the resulting setting
will be incorrect. The level control should be set
while operating at low levels (under 10 watts). If
the level control is set too high due to setting it
at high operating levels the input circuit will clip
and the dynamics of the bass will be lost. The
Red Clip indicator will signify when this occurs.
This can happen without audible distortion
since the filters will filter out the distortion.
is no practical limit
to the number of
LS2100Ps that may
be connected
together.
6. Mono Blend
Input Jack
The Mono Blend
Input jack enables
you to connect
a secondary line