Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 3
NOTE : Do not over-tighten the screws until parts are fully lined up.
1.
Use four (4) 1/4" x 1/2" Phillips roundhead screws with anti-slip design (part #21) to connect the beam (part
#7) with the left-side panel (part #3) and the right-side panel (part #17).
2. Use four (4) 1/4" x 1/2" Phillips roundhead screws with anti-slip design (part #21) to connect the decorative
panel (part #4) with the left-side panel (part #3) and the right-side panel (part #17).
30
Publicité
Chapitres
Table des Matières
