Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 2
NOTE : Do not over-tighten the screws until parts are fully lined up.
1.
Flip over the cabinet floor (part #14). Install two (2) gasket (part #16) into the round openings.
2. Use two (2) Phillips screw (part #22) to install the door stopper (part #15) to the cabinet base (part #14).
3. Use three (3) 1/4" x 1/2" Phillip's roundhead screws with anti-slip design (part #21) to tighten the left-side
panel (part #3) to the cabinet base (part #14).
4. Use three (3) 1/4" x 1/2" Phillip's roundhead screws with anti-slip design (part #21) to tighten the right-side
panel (part #17) to the cabinet base (part #14).
5. Use thirteen (13) 1/4" x 1/2" Phillip's roundhead screws with anti-slip design (part #21) to tighten the back
panel A (part #18) and the back panel B (part #19) to the assembled cabinet base (part #14), left-side panel
(part #3), and right-side panel (part #17).
29
Publicité
Chapitres
Table des Matières
