Hoover Uline H-3956 Mode D'emploi page 4

CAUTION! Operate vacuum only at voltage
specified on data plate on bottom of vacuum.
ON/OFF SWITCh
1. Plug cord into electrical outlet.
2. To turn vacuum ON, push the
ON/OFF switch (H) toward the
front of the vacuum.
(See Figure 11)
3. To turn vacuum OFF, push switch
toward back of vacuum.
CORD STORAGE
CAUTION! Unplug cord from wall before storing.
When finished using vacuum, wrap cord around cord
storage hooks.
hANDLE POSITIONS
The vacuum has three positions:
• Upright for storage and when
using cleaning tools.
• Operating position for
vacuuming carpet and floors.
• Low for reaching under low
furniture.
To navigate each position step on
the handle release lever and lower
the handle. (See Figure 12)
TRANSPORTING vACUUM
• From upright position, tilt the
vacuum back onto the rear
wheels and push forward.
(See Figure 13)
• The vacuum can also be
moved by using the carrying
handle. (See Figure 14)
CARPET hEIGhT
ADjUSTMENT
Carpet and rug cleaning takes
place at the nozzle (I). When it
is necessary to raise and lower
the nozzle for various carpet pile
heights, slide the nozzle control
knob (J) to the desired setting.
(See Figure 15)
PAGE 4 OF 15
INSTRUCTIONS
Figure 11
H
Figure 12
Figure 13
Figure 14
Figure 15
J
I
hANDLE POSITION
For ease in sliding knob, the
handle should be in the upright
position (K). (See Figure 16)
The nozzle will not move into the
adjusted position until the vacuum
handle is lowered to the operating
position (L). (See Figure 16)
SETTINGS
For maximum cleaning
performance, the following
carpet height settings are
recommended:
• Low setting: For bare floor.
(See Figure 17)
• High settings: For deep pile carpet so vacuum is
easier to push. (See Figure 17)
Note: If the vacuum is difficult to push, slide
knob to the next higher setting.
CLEANING LIGhTWEIGhT AREA RUGS
1. Stand on one end of a rug and move the vacuum
toward the other end of the rug.
2. Before reaching the edge, push
down on the handle. This will
lift up the nozzle on the front of
the vacuum and will prevent
the rug from clinging to the
vacuum. (See Figure 18)
3. Continue to lift up the nozzle
so that when you have reached the edge it is
completely off the rug.
4. Move the vacuum back to start again, lower the
nozzle, and use only forward strokes.
STAIR CLEANING
WARNING! Use extra care when cleaning
on stairs. To avoid personal injury or damage,
and to prevent the vacuum from falling, always
place vacuum at the bottom of the stairs or on
the floor. Do not place the vacuum on stairs or
furniture, as it may result in injury or damage.
A stair cleaning handle has been
designed for ease of use. With
handle in operating position,
place fingers under edge of
stair cleaning handle and guide
vacuum with other hand on upper
handle. (See Figure 19)
Figure 16
K
L
Figure 17
HIGH BARE
FLOOR
Figure 18
Figure 19
0514 IH-3956