Cleaning And Maintenance - Redmond SkyScales RS-741S-E Mode D'emploi

The maximum value of the timer setting — 199:59.
3. After setting the value until the last symbol and pressing the
program will start to count down in 1 second increments. When 00:00 value is
reached an audible signal will be heard.
4. To return to the weighing mode press the
press the button.
5. To disable an audible signal at the end of timer operation press the
Disabling audible signals
To disable audible signals during appliance operation press and hold down the UNIT
button for several seconds. A double audible signal will be heard, after that audible
indication will be disabled. To enable audible signals repress and hold the UNIT button.
When disabling audible signals the notification about the end of the countdown will
be enabled.
III. CLEANING AND MAINTENANCE
Do not use abrasive or solvent-based cleaners, metal sponges, etc. Clean the platform
with a soft damp cloth and wipe dry.
DO NOT immerse the unit in water or wash under running water. The scale is not
dishwasher safe.
It is advised to remove the battery, if the scale is not being in use for a long time. Store
the assembled appliance in a dry, ventilated place away from heating appliances and
direct sunlight.
During transportation and storage, do not expose the device to mechanical stress, that
may lead to damage of the device and/or violation of the package integrity.
Keep the device package away from water and other liquids.
IV. BEFORE CONTACTING SERVICE CENTER
Problem Possible cause
The scale is not turned on
The scale does not
work
The battery is worn out
button the
Display shows the error
code: Lo
button. To return to the timer mode
button.
Weight readings are inac-
curate
The unit automatically
turns off
The attempt of synchroni-
zation or transferring the
data from the appliance to
the mobile device failed
Solution
Switch on the appliance by
pressing the button
Replace the battery following
the procedure outlined in
"Before Operating" section
Problem Possible cause
The battery is worn out
You selected wrong unit of
measurement
You did not follow the rec-
ommended weighing proce-
dure
Auto Off feature activated
Bluetooth function on the
mobile device is disabled
Ready for Sky app on the
mobile device is deactivate
The Kitchen Scales and mo-
bile device are far away from
each other or there are strays
for the radio signal
In case you didn't manage to eliminate the defects, please, refer to the authorized
service centre.
NOTE! In case any failure occur in the operation of the Ready for Sky app, it is not
obligatory to apply to the service centre. Apply to REDMOND technical support service
and obtain the consultation of our specialists on error elimination and/or failure in
Ready for Sky operation. Your comments and suggestions concerning application op-
eration will be taken into account upon successive update. Contact data of user support
service of REDMOND appliances can be found in your country on the website www.
redmond. company. You may also obtain the help, filling the contact form provided on
the website.
SkyScales RS-741S-E
GBR
FRA
Solution
DEU
NLD
Replace the battery following
the procedure outlined in
ITA
"Before Operating" section
ESP
Select the desired unit of
measurement PRT
DNK
Always place the scale on a flat
and horizontal surface
NOR
SWE
The scale automatically turns
itself off after use in 5 min-
FIN
utes
LTU
Enable Bluetooth function on
LVA
the mobile device
EST
Run the Ready for Sky app on
the mobile device
ROU
HUN
Ensure the distance between
devices does not exceed 15
BGR
metres and there are no strays
for transmission of radio sig-
HRV
nal
SVK
CZE
POL
RUS
GRE
TUR
UKR
KAZ
7