Operating The Machine - Makita DCU180 Manuel D'instruction

1
► 1. Short hexagonal bolt
CAUTION:
Extend the rear wheels to the max-
imum to keep balance. When the rear wheels are
not extended, keep the load to a minimum.
NOTICE:
Fix the rear wheels at the same position
on both sides.
Adjusting the width of the carrier
Loosen the 6 thumb nuts, and then slide the front and
side rails. Tighten the thumb nuts to fix the front and
side rails.
1
2
1
► 1. Thumb nut 2. Rail
CAUTION:
Do not slide the rails beyond the
limit mark.
1
1
16 ENGLISH
OPERATION

Operating the machine

NOTICE:
The front wheel is driven by battery
power in this machine. Use this machine to assist
with carrying operations.
NOTICE:
Be sure to insert the lock key in the bat-
tery box before the operation. If the lock key is not
inserted, a short beep sound is emitted when you pull
the switch trigger. The beep sound stops by releasing
the switch trigger and pulling the brake lever.
1. Select the battery cartridge with the battery selec-
tion switch.
2. Press the power button on the control panel for a
few seconds to turn the power on.
► 1. Power button
3.
Pull the brake lever to release the lock of the
brake lever.
► 1. Lock button 2. Brake lever
NOTE: Release the rear wheel brake if the rear
wheels are installed.
4. Hold the handles firmly with both hands.
1
1
2