Functional Description - Makita DCU180 Manuel D'instruction

FUNCTIONAL
DESCRIPTION
Installing or removing battery
cartridge
CAUTION:
Always switch off the machine
before installing or removing of the battery
cartridge.
CAUTION:
Make sure that you lock the battery
cover before use. Otherwise, mud, dirt, or water may
cause damage to the product or the battery cartridge.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the machine, causing
injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
CAUTION:
Do not use the high-temperature
battery cartridge. When the high-temperature bat-
tery cartridge is used, the machine stops automati-
cally before a short beep sound is emitted, and may
cause an injury.
Installing the battery cartridge
1. Rotate the lock lever, and then open the cover of
the battery box.
1
2
► 1. Lock lever 2. Cover
2. Align the tongue on the battery cartridge with the
slot on the battery box, and then slide the cartridge until
it locks in place with a little click. If you can see the red
indicator on the upper side of the button, battery car-
tridge is not locked completely.
1
► 1. Battery cartridge
3. Insert the lock key in the place shown in the figure
as far as it will go.
1
► 1. Lock key
NOTE: If the lock key is not inserted completely, the
machine does not work.
4.
Close the cover of the battery box, and then rotate
the lock lever.
1
2
► 1. Lock lever 2. Cover
11 ENGLISH