Control Panel - Makita DCU180 Manuel D'instruction

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.

Control panel

► 1. Power button 2. Forward/reverse button 3. Speed
button
To turn the power on, press the power button for a few
seconds. Press the forward/reverse button to switch
between the forward mode and reverse mode. Press
the speed button to switch between low speed and high
speed. When the power is turned on, the forward mode
and low speed are set. To turn the power off, press the
power button for a few seconds.
NOTE: The forward/reverse button is not available
while pulling the switch trigger.
NOTE: A short beep sound comes out when operat-
ing the machine in reverse.
NOTE: The speed button is not available when oper-
ating the machine in reverse.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1
2 3
Switch and brake action
WARNING:
tridge into the machine, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the machine, pull the switch trigger. To stop the
machine, release the switch trigger and pull the brake
lever. To lock the brake lever, press the lock button
while pulling the brake lever. To release the lock, pull
the brake lever.
1
► 1. Switch trigger
► 1. Lock button 2. Brake lever
Rear wheel brake
The rear wheel on the left side is equipped with a brake.
Press the brake pedal toward the front to lock the brake. To
release the brake, press the brake pedal toward the rear.
► 1. Pedal
14 ENGLISH
Before installing the battery car-
1
1
2