Parameters Menu - MORGAN Catering Equipment CLEAN WATER Manuel D'utilisation

16.

PARAMETERS MENU

Here follow the parameters:
Ready Blr Temp
Max Tank Temp
Solen Valve Tmr
Tmr Deter Load
Tmr RnsAid Load
Cyc I Wash Tmr
Cyc I Rinse Tmr
Cyc I Deter Tmr
Cyc I RnsAid Tmr
Cyc II Wash Tmr
Cyc II Rinse Tmr
Cyc II Deter Tmr
Cyc II RnsAid Tmr
Cyc III Wash Tmr
Cyc III Rinse Tmr
Cyc III Deter Tmr
Cyc III RnsAid Tmr
Pause Timer
Modbus address
SW Release
cod.W010006
All manuals and user guides at all-guides.com
Parameter that regulates the temperature of the boiler ready for rinsing.
Parameter that sets the maximum temperature of the tank, above which the
heating element is turned off.
Parameter that sets the load solenoid valve activation time by which the boiler
must be filled.
Parameter that sets the activation time of the detergent peristaltic pump during the
loading phase.
Parameter that sets the activation time of the rinse aid peristaltic pump during the
loading phase.
Parameter that sets the activation time of the wash pump during cycle I.
Parameter that sets the activation time of the rinse pump during cycle I.
Parameter that sets the activation time of the detergent pump during the cycle I
Parameter that sets the activation time of the rinse aid pump during the cycle I
Parameter that sets the activation time of the wash pump during cycle II.
Parameter that sets the activation time of the rinse pump during cycle II.
Parameter that sets the activation time of the detergent pump during cycle II
Parameter that sets the activation time of the rinse aid pump during cycle II
Parameter that sets the activation time of the wash pump during cycle III
Parameter that sets the activation time of the rinse pump during cycle III.
Parameter that sets the activation time of the detergent pump during the cycle III
Parameter that sets the activation time of the rinse aid pump during the cycle III
Parameter that regulates the amount of time between wash cycle and rinse cycle.
Parameter that controls the serial communication address.
This view identifies the software version (release) number printed on the card.
Pag. 17 01/08/2019