Frigidaire AEQ7000CES0 Instructions D'installation page 6

Be sure to wear gloves while reversing the door assembly.
1. Open the dryer door.
2. Remove the two #10-16x.50 that secures the door
assembly to the front panel. NOTE: Remove the bottom
screw first. Support the door assembly firmly before
removing the top screw.
3. Remove the door assembly by lifting and pulling toward
the center of the unit opening.
4. Place door assembly face down on a soft flat surface.
5. Remove the two round plugs and one "T" plug from the
front panel. Reinstall them in the position vacated by
the hinge.
6. Remove the five #10-14x5/8 screws, 1 thru 5 and the
two #10-16x.50 screws, 6 thru 7, that attach the inner
door assembly to the outer door assembly. Lift the inner
door assembly out of the outer door assembly.
All manuals and user guides at all-guides.com
DRYER DOOR REVERSAL INSTRUCTIONS
7. Remove the two #10-16x.50 hinge attachment screws
and the two #10-16x.50 striker plate attachment
screws.
8. Rotate the hinge and strike plate and reattach them to
the opposite sides of the inner door.
9. Remove the hinge cutout plug. Rotate it and install it in
the opposite side of the outer door.
10. Reattach the door assemblies in reverse order.
11. Support the door assembly firmly; insert the hinge "T"
post into the "T" slot in the front panel and lift to align
the screw holes.
12. While supporting the door assembly, install the mount-
ing screws.
13. Close the door.
6