On/Off Switch - CLAS OE 5052 Mode D'emploi

OE 5052
BOOSTERS
OE 5051
OE 5050
OE 5150
OE 5151
B. ON/OFF SWITCH
If your Start Booster is equipped with an ON/OFF Switch, please read the following.
Diff erent types of switches:
• On the Booster itself.
• Inside the handle of the negative (black) clamp.
On the unit itself, please just turn it OFF or ON according to the labels on the switch.
Inside the clamp, push the clip upwards to turn it ON and downwards to turn it OFF.
There is a sign on the handle as well to remind you. See the image below.
ON/OFF
clamps
- UP position is ON
- DOWN position is OFF
Always have your device turned OFF when not in use or when connecting your clamps to your
vehicle or battery. Only turn it ON after you made sure the clamps are properly connected to the
vehicle. Once the vehicle has started please remove the Negative clamp fi rst, then turn your ON/
OFF switch OFF and then the positive clamp.
C. REVERSE POLARITY ALARM
The reverse polarity alarm, or buzzer, will emit a sound and a light when it detects a reverse
polarity.It can only work with an ON/OFF switch located on the booster or on a 12/24V model. To
make sure it is used properly, always have the booster turned OFF or disconnected before use.
Then connect the clamps to the vehicle's terminals or battery and at this moment the alarm
will emit a noise and light if it detects a reverse polarity connection. If the clamps are properly
connected, nothing will happen. In this case, you can then turn your unit ON, or select the proper
voltage on a 12/24V model before jump starting your vehicle.
D. 12/24V CONNECTOR / SWITCH
The 12/24V models are either equipped with a Switch or with a Red Connector.
In both cases the unit can be turned OFF, by either placing the switch in the center (position OFF),
or by pulling the red connector out (please make sure not to pull on the cables but only on the
connector handle).
Then to select the proper voltage, please refer to the battery of the vehicle (by reading the user
manual of the vehicle itself). Once you have made sure of the voltage, either turn the switch on
12V or 24V, or plug the red connector on the side of the 12V or the side of the 24V. It is important
to select the correct voltage to avoid damaging the vehicle, or booster and to void any explosion
due to over charge.
Before turning it ON, make sure that the clamps are properly connected and that there is no
reverse polarity. Then turn the Booster ON to jump start the vehicle. Once
clip on negative