CLAS OE 5052 Mode D'emploi page 11

OE 5052
BOOSTERS
OE 5051
OE 5050
OE 5150
OE 5151
• Children should be supervised to ensure that they do not play with the device
• Replace the clamps and cables after each use
• Acid and battery gases are dangerous. Never touch or inhale it.
• Be careful when working near a motor and its moving parts. Always check the vehicle voltage
fi rst.
• Never recharge or start a frozen (or very cold) battery. It can be very dangerous
• Try to keep this product at room temperature (15-25°C). Never leave it outside, in the rain, cold
or hot.
SPECIFICATIONS
A. SAFETY FUSE
If your booster is equipped with a Safety Fuse please read the following:
Fuses have been developed to protect your booster and vehicle against reverse polarities. If your
jump starter is not already equipped with a safety, you still have the possibility to add a new type
of clamp with a built-in safety fuse. Please contact your distributor directly to ask if your device
is compatible.
Diff erent Types of Fuses:
Fuses exist in various sizes: 300A – 500A – 1000A. Please check which fuse was installed in your
device before ordering a new one. You can ask your distributor if you need to change a fuse.
Please make sure that you use a recommended fuse only.
Using a fuse that is not approved will void the warranty.
Fuse locations:
Depending on the model of booster, the fuse can be located in various places:
• On the booster itself, either on the front or the back of the unit.
• Inside the handle of the positive clamp.
Our fuses come with a small window to see if the fuse is broken or not. Sometimes, depending on
the features, you might have an extra spare fuse directly built-in the unit itself to be able to change
it if the one connected has burst.
Fuses are very easy to change. First open the window with a screwdriver and then remove the two
bolts holding the fuse.
Be careful not to remove the two bolts behind the fuse. Then replace the fuse and tighten the two
bolts to hold the fuse.
Please also note that the physical
dimension of the fuse will vary,
depending if it is a fuse for the
booster itself or a fuse that is
installed inside the clamp.
Fuse on the positive clamp
1. slide handle backwards
2. take out fuse