Heitronic 27010 Instructions D'installation Et D'utilisation page 6

H. Vollmer GmbH
4. Before installation/commissioning

The LED-Panel may only be operated after removing the packaging.

Take the LED-Panel carefully out of the packaging.

Before commissioning the LED-Panel make sure that it has not been damaged in transit. The LED-
Panel must not be operated if the electrical components have been damaged. Repairs may only be
undertaken by a specialist electrician.

Keep the packaging material well away from children and household pets. Danger of suffocation!
5. Installation/Commissioning

This product may only be installed by a qualified specialist electrician.

Before the installation is done, the connection lines to the building must be disconnected from the
power supply and protected against being switch on accidently. Take the appropriate automatic circuit
breakers out of the junction box in the building.

Make sure that the foundation is suitable to support the weight of the LED-Panel, permanently and
reliably.

Hold the panel / panel housing at the desired site of installation and mark the drill holes. Use suitable
screws to fasten the LED panel. Make sure that no connections are damaged.

Do not bend the cable; make sure that the cable and the plug are free from any tractive and torsional
forces. Protect all cables and insulations from any possible damage.

Check the proper connections once again.

Switch on the circuit breakers of the junction box in the building once again.
6. Functional faults
The LED panel does not switch on

Is the switch of the LED panel on the wall turned on?

Is the transformer correctly assembled and connected?

Check the connected lines
Installation instructions Art. No: 27010-27017 Page 2 of 3
®
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach Stein
Status 01.12.2015