Pleasant Hearth GLF-5002-50 Mode D'emploi page 11

OPERATING INSTRUCTIONS
The infrared remote control relies on a line of sight and must be pointed at the controls of the log set to
work . The remote control unit has the controls required to turn ON/OFF both the main power and the
heater . If you prefer to use the control buttons on the log set unit itself, they are on the lower right corner
of the unit . The layout of the buttons and remote control unit can be seen in Figures 2 and 3, respectively .
Plug your log set into a 15-amp, 120-volt power outlet.
1 . Turn the power on . Flame will show on the wall
behind the log set .
2 . Remove the plastic tab from inside the battery
compartment to activate the remote control .
3 . Point the remote control directly at the control buttons
of the log set and use the buttons to operate the log set .
Main Power Button (1):
This button supplies power to all the functions of the
electric fireplace. The main power button must be in the
ON position, either from the remote or the controls on the
electric fireplace for the functions to work.
Heater Control Button (2):
This button controls the heater ON/OFF and 5 temperature
modes from Low to High. When the heater is first turned
on, the heater will come on at the lowest room temperature
setting . The log set will remember the last heat setting . In
later use, the heater will start at that setting, unless power
to the unit has been interrupted . Each time this button is
pressed, the temperature set point increases, allowing you
to adjust the ambient temperature .
Flame Control Button (3):
This button controls the brightness of the flame effect
with settings at High, Medium and Low . When the log set
is first turned on, the flame will come on at the highest
setting. The log set will remember the last flame setting
used. In later use, the flame brightness will start at that
setting, unless power to the unit has been interrupted . Each
time the Flame button is pressed, the flame brightness
decreases. The only way to turn off the flame effect
completely is to turn off the Main Power button .
Battery Replacement Procedure: (Size CR2025)
IMPORTANT: Under normal operation, when power is
interrupted from either an outage or from unplugging unit
from wall while still in operation, the heat level indicator
lights may blink repeatedly and the unit will cease
operation . In order to reset the unit, unplug for 10 minutes,
then plug back in and operate normally in accordance with
the Use and Care Guide .
11
The plastic tab inside the battery
compartment MUST be removed
before the remote control will operate.
(Pull tab)
1
2
3
Figure 3