Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Figure 1
national and state/provincial
electrical codes.
!
NOTE: It is recommended
that the bottom of the unit
not be mounted higher than
1020mm (40") from the
Fireplace Installation ground
to maintain an optimized
viewing angle of the flame.
(Figure 2)
! NOTE: Wall anchors must
be installed in the appropriate
wall locations to fasten the wall
bracket to drywall. (Figure 3)
3. Hold the wall hanging
bracket on the wall and mark
the location of ONE of the
securing holes.
4. Place the bubble level onto
the top of the wall hanging
bracket.
5. Adjust the wall hanging
bracket so the bubble on the
Figure 2
level is centered between the
two black lines.
6. Mark the two (2) screw
locations, on the wall,
ensuring that the wall bracket
stays level.
7. Install the supplied wall
anchors on the drywall
marked locations by placing
a #2 Phillips screwdriver into
the recess of the anchor.
8. Press the anchor into the wall
7
Publicité
Chapitres
Table des Matières
